Category Archives: Overshot

First project

IMG_5674After a trip to Aruba I finished setting up the Spring loom to begin weaving.  It required learning new skills to get this far. Yes, I’ve been weaving for over 30 years but there are always new things one can learn about ways to use equipment.

Back to front, Front to back, how do you put on your warp. I had been warping from the front for over 30 years. It started when I was using mixed warps. Then I just got comfortable with doing it that way. So with the Spring I forced myself to learn once again how to warp from the “Back”.  The raddle with all the small divisions on the Spring seemed tedious, but that warp sure wound on nice. Threading texsolve heddles is quite different than metal heddles. After threading almost 500 Heddles I seemed to find a way to hold them to make threading more efficient.

Monday I sat down to weave. Of course 3 threading errors had to be fixed before continuing. My first 3 weft throws were good. Then I depressed the  4th treadle, or so I tried. I could not get a shed. I was  perplexed. Everything appeared fine. What had I done. The loom is tied up like a countermarche loom. Every heddle gets tied to a treadle whether used or not. Here in lay the problem. That particular harness had been tied to both a rising and sinking Lamm. A harness should only be tied to one or the other. Problem found and solved.

My first warp on the loom is for these cheerful towels. The warp and weft are both 8/2 cotton threaded 24 ends per inch.  An 8 harness overshot. By the time the warp is woven off I should be much more familiar with my new friend.IMG_4065

The view from our room in Aruba. The hotels were all along the beaches on this side of the island.

On the other side of the island the beaches are covered with dead coral. The water here is much rougher.  The second picture is a large volcanic rock.

IMG_4020

The sunset made for a beautiful evening dinner. The next two nights were cloudy, so this was our best sunset.